Search Results for "python games code"

This python utility allows users on Linux to control their PC using a HID compatible USB foot pedal. Note: footcontroller does not support the new VEC Infinity in-USB3 pedal, which is not fully Linux compatible The foot pedal becomes an extra mouse or mini keyboard but footcontroller allows you to define multiple pedal sets which you can activate at the click of a button. It uses xdotool to provide you with the ability to assign commands to each pedal. Many foot pedals come with...

This project includes a spin/wait handler for processing reset/shutdown behavior from a button, configuration files for setting this up as a service, and instructions for placing the files and enabling the service.

Note: The project has moved to https://github.com/pyhys/minimalmodbus The files available here are very old, download from Github instead. MinimalModbus is an easy-to-use Python module for talking to instruments (slaves) from a computer (master) using the Modbus protocol, and is intended to be running on the master. Example code includes drivers for Eurotherm and Omega process controllers. The only dependence is the pySerial module (also pure Python). This software supports the ‘Modbus RTU’ and ‘Modbus ASCII’ serial communication versions of the protocol, and is intended for use on Linux, OS X and Windows platforms. ...

Roundhouse is a pair of C based embedded software applications to drive model railroad stepper motor based turntables. It consists of a stepper motor code and controller code connected by an I2C network. Written in C for PIC18/PIC16s processors.

Sample code for controlling the Juiceboss web power controller.

This project is a POSIX-compliant driver for the dgt board from dgtprojects. It is intented at acting as a layer between chess engines and the dgt board.

This software is the going to be used in a small office refrigerator to controll the thermostat. Currently the code is written for the PIC16F84 in assembler. The code is fully compilable in MPLAB.

This low cost project is a RC servo like position control of one or two geared motor(s) with a pot as angle feedback. You can send the arduino microcontroller a value from 0 to 1023 and the arduino will control the motor speed and direction to reach your target value. The PID algorithm will insure that the motor will not get into hold vibrations if the pot has some influences. This article will describe where you have to take attentions and what you have to setup to get the best results. The...