Search Results for "algorithm code writer"

Serpent_in_CBC_mode_for_microcontrollers is an open-source code that enables you to easily integrate the Serpent encryption algorithm in CBC mode to your project. Based on the work of https://github.com/peterferrie/serpent GitHub Page: https://github.com/Northstrix/Serpent_in_CBC_mode_for_microcontrollers

... megaAVR series (ATmega328P, ATmega1284P, ATmega2560, ATmega32U4, AT90USB1286, etc.) as well as the new megaAVR 0-Series (ATmega4808, ATmega4809, etc.). On the other side, while eCxx is primarily designed to work in NodeMCU, it should also support other ESP-12 based design as well as ESP-01 based design. The Makefile build system and some of the tools would only run on Linux. However, the library source code should be portable enough to be built using other build systems for AVR and NodeMC

This project was originally designed to provide an open-source replacement for PPJoy. The product, at this point, consists of virtual joystick devices that is seen by the system as a standard joystick but its position-data is written to it by a feeder application. An existing feeder application that takes advantage of this product is SmartPropoPlus. If you are an application writer you can very easily write an application that controls a joystick (e.g. mouse-to-joystick, keyboard-to-joystick...

The project page provides the source code of custom built simulators used in our publications whose URL are given as follow: http://dx.doi.org/10.1016/j.comcom.2013.09.006 http://dx.doi.org/10.1109/PIMRC.2009.5449983 The titles of the papers are: Online XOR packet coding: Efficient single-hop wireless multicasting with low decoding delay (COMCOM VERSION). An efficient network coding based retransmission algorithm for wireless multicast (PIMRC VERSION). Help (README) files...

Simple GUI based lightweight duplicate file finder and remover. Configurable file search and preview (via external tools) option for file data. No command-line interface available! This is basically a reimplementation of dupfinder as: it doesn't compile on my computer, the executable won't work either, the projects seems dead and I didn't wanna work through the original code. So Look'n'Feel should be somewhat the same, though some changes have been made. Algorithm is simple and suitable...

XinDiff is a diff utility implementing WinDiff like GUI by an improved LCS algorithm. The key feature in addition to WinDiff is in-place comments for code review.

Flying Ants implements a wireless ad-hoc routing algorithm based upon biologically inspired ant-like agents. The code is suitable for single board computer systems (e.g., soekris boards). It runs in userland and utilizes a threaded raw socket protocol.

This low cost project is a RC servo like position control of one or two geared motor(s) with a pot as angle feedback. You can send the arduino microcontroller a value from 0 to 1023 and the arduino will control the motor speed and direction to reach your target value. The PID algorithm will insure that the motor will not get into hold vibrations if the pot has some influences. This article will describe where you have to take attentions and what you have to setup to get the best results...