Sure, there is already the KiCAD file including everything to play around with on your own; added a picture of the schematic here for a quick glance without downloading.
Thank you both for your answers.
With so many parameters to play with, it was not easy to understand what was wrong.. But I think I finally got a way do get my hardware working
Here are my findings :
I thought I got RFM73 version of NRF24-like radios. They look like like here and here.
After checking and connecting all VCC and GND together, switch radios and arduinos... I got them suddenly working with Mysensors development librairies, then back to silence without apparent reason...
Indeed like @mark_venn suggested, I went back to stable librairies and try so set a static ID. Worked well... until it went back to silence again !
Then, following @mfalkvidd advice, I realised that flashing the eeprom_clear sketch solved my all my problems !
My summary :
Ensure that your 3.3V power supply is strong enough.
Ensure that your arduino, radios and sensors are sharing the same GND and VCC.
Use development librairies from github
Flash eeprom_clear before flashing your mysensor sketches
Then gatewaySerial and relayActuator should be able to communicate "out of box", mean you'll monitor some lines like this on the gateway serial : 0;255;3;0;9;read: 0-0-0 s=255,c=3,t=15,pt=0,l=2,sg=0:
Thanks again for your help, now I can start to play
@DeepCore not wrong frequency no. But it looks like the feather doesn’t come with the antenna pre-soldered. Since the devices should be identical otherwise, the antenna could be what differs. But if it was, the rssi would probably have been different as well.
Does anybody have a link to a fixed version of this board? It's exactly what I am looking for form-wise, but I'd be nice if VCC was wired to 3.3v out of the box. Thanks!!
Hi, not sure if @Floca get his nodes working, but for me, the problem got fixed with this
#define MY_RF69_IRQ_NUM MY_RF69_IRQ_PIN
as mentioned by @mfalkvidd Thanks!
